|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Specifications
Material: Silicone
Carrier removal: Cold Peel
Remove carrier before application: Yes
Dimensions: 5,2x5,2cm logo, 3,5x2cm crown
If you need more precise dimensions, please contact us by email or send us a private message.
Universal Application Instructions
Before applying the print, we recommend lightly pressing the garment with a heat press or iron for 1–2 seconds to remove moisture and wrinkles.
Depending on whether the print requires the carrier film to be removed before application, position it carefully over the restoration area. We recommend cutting the print into smaller sections and aligning each part individually. Due to heat exposure, washing, and the natural ageing of fabrics, every shirt may differ slightly from the original print dimensions.
Heat Press
- Temperature: 145°C
- Time: 9–12 seconds
- 3D Flock prints: approximately 20 seconds
Household Iron
Set the iron to the highest temperature (without steam) and apply firm pressure for approximately:
- 10 seconds for standard prints,
- 20 seconds for 3D Flock prints.
After pressing, remove the carrier film according to the product specification (hot peel or cold peel).
Always use heat transfer paper, parchment paper or baking paper during application. We also recommend using an ironing board or Teflon pillow so that only the side of the garment with the print is exposed to direct heat.
Do not wash the garment for at least 24 hours after application.
Do you have questions about the application process, dimensions or choosing the correct print? Check our FAQ or contact us – we're happy to help.